3. Remove the old battery.
4. Replace the old battery with a new CR1632 battery cell, ensuring the positive+ is facing upwards.
5. Check that the water-proof rubber seal is in the correct position. Screw the sensor cap back using the battery replacement tool to
tighten.
Installing 188 PSI sensors.
The 188 PSI sensor comes in a security housing but can be installed with or without it. You can remove the security housing by simple
unscrewing the casing before connecting the sensor to the appropriate tyre valve.
User tip: It is recommended to pair the sensors using the LF pairing method first before connecting the 188 PSI sensor to your tyre
valve.
Before connecting the sensor to the tyre valve, shake it to ‘wake it up’. This will ensure it is ready to pair.
1. Remove the tyre valve cap and mount the corresponding sensor on the valve using the wrench provided.
CR1632
"-" " " +
CR1632 Lithium Battery CR1632 Lithium Battery
To Next Page
Loading...
Need help?
General
