18
NOTE: This V3 CFD torque checking method is possible do to with the chain on.
Just put the bike on a stand so that the rear wheel can turn freely.
NOTE: The CFD hubs can be removed with the universal puller (MCMUTL70).
If it slips below the value, the CFD must be readjusted as per described in the
service section of this manual.
NOTE: If the bike makes a whir, whir, whir, sound coming from the clutch side
engine cover it is very probable that the CFD has slipped enough that the brass
bushing has worn sufficiently to let the gear operate off center. Time to install a
CFD refresh kit (EKMU0033).
To Next Page
Loading...
