- 21 -
TV Function
Auto Memory
Use the _/_ buttons to select “Auto Memory”, press the “ENTER” or _ button to auto
scan for channels:
Scanning will take a few minutes. The unit will search channels from the lowest channel
to the highest channel in the standard channel list. When scanning is complete, the unit
will exit and store the channels.
During scanning, press the _ button to exit the auto scan.
Use the _/_ direction buttons to go to the previous or next channel found.
Timer Setup
Press the “SET” to enter Timer Setup menu, the screen will display as below:
Use the _/_ buttons to select the item you want to set.
Use the _/_ buttons and the number buttons to adjust the seting.
Press the “SET” button again to exit from the Timer Setup menu.
Timer
Use the _/_ direction buttons to select “ON” or “OFF”. This function allows you to set the
start time and end time of the desired signal source. No matter what mode the unit is in,
this function will automatically turn the unit on in the desired signal source.
Select “ON” to activate this function; select “OFF” to disable the function.
To Next Page
Loading...
