Code Alarm Professional ca5054 - Remote Start Control Feature Descriptions

4 - Trunk
Output
Timing - Red/White
Output: Controls
the output timing/type of the
RED/WHITE output.
1
Second Pulse -
1 second
pulse
output.
1
0 Second - Continuous output for 1
0
seconds.
20 Seconds
- Continuous output for
20
seconds.
Latched
until IGN
ON
- Continuous output
until
the vehicle's
ignition
is
turned
ON.
Latched
ON
until
Button Press - Continuous output
until the activation button
is
pressed again.
5 -
Horn
Output
Timing:
Control
the minimum horn
pulse time
in
milli
seconds,
some
vehicle will
require a
longer
pulse
to activate the factory horn.
16mS
1
OmS
30mS 40mS 50mS
6 -
Real
Panic:
Controls
the panic out when triggered from the transmitter.
ON
- Randomized horn honks when panic
is
triggered.
OFF-
Standard pattern horn honks when panic
is
triggered.
Feature Bank 4 - Remote Start Control
1 -
RF
Start Chirp: Turns remote start activation confirmation chirps
ON
or
OFF.
2 - Run Time:
Controls
the time
in
minutes that the
vehicle will stay running under
control
of
the remote start
until
the system times out. The system may
also
be shut
down at any time by use of the transmitter or system shutdowns.
3 - Running Lights:
Controls the WHITE
parking light output wire during remote
start.
Steady-
Parking
lights
constant during the remote start
cycle.
Flashing
- Parking
lights flash
at a
slow
pace during the remote start
cycle.
2014 Voxx Electronics Corporation. All rights reserved.
21