EasyManua.ls Logo

Code Alarm Professional ca5054 - Page 22

Code Alarm Professional ca5054
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
4 - Tach Mode: Determines how the system monitors the engine running during
remote start.
Tach - Hard wired directly to the tach wire
of
the vehicle to monitor AC
voltage.
Tach less (Crank Average/Voltage) - Determines crank time by averaging the
last 8 times the vehicle was started with the key and then monitors the
change
in
voltage after remote start.
Hybrid (Crank Average
I No Voltage)- Determines crank time by averaging
the last 8 times the vehicle was started with the
key.
OBI
Port - Monitors the vehicle's tach rate through
an
interface module
connected to the
OBI
port.
5 -Voltage Level: The voltage variance for remote start when set to tachless. (see
tach mode)
HIGH - The variance
in
battery voltage from before the remote start
is
activated to after the engine is running must be greater than 0.5 volts.
LOW - The variance
in
battery voltage from before the remote start
is activated to after the engine is running may be less than 0.5 volts.
6
-Crank
Time: Preset output times for the PURPLE starter wire.
1 Second 0.8 Seconds 1.5 Seconds 2 Seconds 4 Seconds
7 - Crank Average I Crank Time: The length
of
time
in
which the remote start will
crank the vehicle's starter.
Crank Average - Determines crank time by averaging the last 8 times the
vehicle was started with the
key.
Preset
Time-
Preset starter output time. (see crank time)
8-
Gas I Diesel: Selects engine type and delay time for the starter output wire
during remote start activation.
Gas-
Gasoline engine, no delay for the starter output wire.
10 Second Delay - Diesel engine, delays the starter output wire for 1 0
seconds after the ignition has been powered up by the remote start.
15 Second
Delay-
Diesel engine, delays the starter output wire for 15
seconds after the ignition has been powered up by the remote start.
20 Second Delay - Diesel engine, delays the starter output wire for 20
seconds after the ignition has been powered up by the remote start.
45 Second
Delay-
Diesel engine, delays the starter output wire for 45
seconds after the ignition has been powered up by the remote start.
ca5054 Install rev
A.

Related product manuals