9 OPERATORS MANUAL VITRO LINE
Operators Program
The Operator’s Program provides access to the machines audit facilities, allows the operator to
set the machine in or out of service and access an alternative method of clearing the grout bucket
full condition.
Keypad functions when used in the Operator’s programming mode, are as follows:-
1) Key (ENTER) used to access a function.
2) Key (ESC) used to escape from the operators mode.
3) Key (PROG) used to access the operators program, then used to change menu functions.
4) ARROWS UP (), DOWN (), LEFT (), RIGHT () are used for adjustments when in
program mode.
5) STAR (*) key is used for selecting option when in output test mode.
Accessing the Operators Mode
Accessing the Operator’s Program is by pressing the PROG key on the internal keyboard. The
display will show:
PRESS DRINK TO DISPLAY COUNTER
Display Counter
The DISPLAY COUNTER option is accessed on entering the Operator’s Program. The resettable
vend counts may be viewed by pressing each drink key (as shown on the capacitive touch
screen) in turn.
To access other options, press PROG on the internal keypad. The other options are as follows:
TOTAL VENDS
RESET COUNTERS
DISABLE VENDS
VIEW INGREDIENT COUNTERS
MACHINE SERIAL NUMBER
OUTPUT AUDIT DATA
Fill MDB TUBES
Total Vends
Access the TOTAL VENDS COUNT option using PROG key, the display will show total vend
count.
Reset Counters
Access RESET COUNTERS by using PROG key, to clear drink counters press ENTER. The
display will show:
ARE YOU SURE
ENTER (Y) ESC (N)
To Next Page
Loading...
Need help?
General
