Precautions
To reduce the risk of injury or equipment damage, observe the following precautions when you install the Cognex
product:
l This device requires the use of an LPS or NEC class 2 power supply (non-PoE device) or the use of a PoE Class
1 (PoE device).
l Do not connect or disconnect this device from the I/O module or 15-pin USB adapter cable when the I/O module
or adapter cable is connected to a PC.
l Route cables and wires away from high-current wiring or high-voltage power sources to reduce the risk of
damage or malfunction from the following causes: over-voltage, line noise, electrostatic discharge (ESD), power
surges, or other irregularities in the power supply.
l Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
the user’s authority to operate the equipment.
l Ensure that the cable bend radius begins at least six inches from the connector. Cable shielding can be
degraded or cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the
cable diameter.
l This device should be used in accordance with the instructions in this manual.
l All specifications are for reference purposes only and can change without notice.
47
Precautions
To Next Page
Loading...
