Networking Settings
NET IP arg1 Set network IP address
NET GW Set network gateway address
NET NM Set network netmask
NET PORT Set network port #
NET DHCP Set DHCP to dynamic or static
NET AD Set network autodrop connection
NET HOSTNAME arg1 Set network hostname
NET? Query network settings
NET? HOSTNAME Query network hostname
NETM? Query network MAC-ID
Common Commands
*CAL? Calibrate Self-Test and Return Status
*CLS Clears the instrument settings
*IDN? Identication String (model and serial number)
*RST Reset instrument
*TST? Self-Test Trombone and Return Status
*OPC Set Operation Complete Bit
*OPC? Query the Operation Complete Bit
Relay Commands for Models XT-100-001N
thru XT-100-100N
REL arg1 [ on | off ] Relay command set
REL? Relay query
RELC arg1 Relay exercise cycles
18
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL
To Next Page
Loading...
