Colby Instruments XT-100 - Common Commands

65 Common Commands
*CAL? Calibrate Self-Test and Return Status
*CLS Clears the instrument settings
*IDN? Identication String (model and serial number)
*RST Reset instrument
*TST? Self-Test Trombone and Return Status
*OPC Set Operation Complete Bit
*OPC? Query the Operation Complete Bit
*CAL? Calibration Self-Test Check? (QUERY)
Description
Performs a calibration self-test check on the electromechanical trombone and returns status
Returns
0 Calibration self-test passed.
1 Calibration self-test failed. Service Required.
*CLS Clear Status (QUERY)
Description
Clears the instrument and resets any pending errors codes.
Returns None
*IDN? Instrument Identication Information (QUERY)
Description
Returns the Instrument identication information.
Returns Colby Instruments,XT-100-625P,11111234,V100
*RST Reset instrument (QUERY)
Description
Performs an instrument device reset to its initial power-on state. Delay is set to zero delay setting in all
channels.
Network IP addresses (if previously changed) will take effect
Returns None
*TST? Calibration Self-Test Check (QUERY)
Description
Performs an internal self-test by moving the electromechanical trombones to the maximum range limit,
testing the optical sensor detection, returning to zero delay position, and re-initializing all internal variables.
Returns
0 Internal self-test passed.
1 Internal self-test failed.
26
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL