*OPC Operation Complete Status Bit Set (COMMAND)
Description
Sets the Operation Complete Status bit when all pending device operations have nished. This is the default
behavior for all command operations.
NOTE: The XT-100 blocks (i.e., does not return if queried using *OPC?) until all operations have completed.
Use this query and return value to synchronize with automation application.
Returns None
*OPC? Operation Complete? (QUERY)
Description
Returns the status of the Operation Complete Status bit.
For all delay setting commands, the Operation Complete Status bit is set after the operation has completed
(trombone motor movement has completed). *OPC? query should be used to synchronize setting the delay
and waiting until the operation has completed.
Returns
0 operation has not started yet
1 previous operation has completed
27
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL
To Next Page
Loading...
