Colby Instruments XT-100 - Chapter 6.0; Application Programming Interfaces (API) and Commands

Chapter 60
Application Programming Interfaces (API) and Commands
The following commands are specic to the XT-100 instrument:
Setting Delay Commands and Queries
DEL arg1 [ ps | ns ] Delay command set delay in active channel
DEL? Delay query both channels
ERR? or *ERR? Error query error status code
System Commands
DEC Decrement step command
INC Increment step command
MODE 625 ps Relay command set
MODE 3125 ps Relay query
MODE par | 3125ps set parallel trombone mode (to 0.25 ps step)
MODE ser | 625ps set serial trombone mode (to 0.50 ps step)
UNITS ns set units mode to ns for numeric values
UNITS ps set units mode to ps for numeric values
UNITS? returns current units mode for numeric values
STEP arg1 [ ps | ns ] Step command set step size
STEP? Step query step size
Calibration Table Commands and Queries
CTSTORE arg1 arg2 Store one entry into calibration table
CTSTORE on | off Use calibration table command
CTSTORE save Save calibration table to NVRAM
CTSTORE load Load calibration table to memory
CTSTORE info Report calibration table information
CTSTORE reset Reset and clear calibration table
CTSTOREM Store multiple entries into calibration table
CTSTORE? Use calibration table query
CTSTORE? arg1 Query individual entries in calibration table
17
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL