Colby Instruments XT-100 - Networking Settings

64 Networking Settings
NET IP arg1 Set network IP address
NET GW Set network gateway address
NET NM Set network netmask
NET PORT Set network port #
NET DHCP Set DHCP to dynamic or static
NET AD Set network autodrop connection
NET HOSTNAME Set network hostname
NET? Query network settings
NET? HOSTNAME Query network hostname
NETM? Query network MAC-ID
NET Network Settings (COMMAND)
Description
The NET command sets the network addresses and other network settings for the instrument. Addresses
are stored in non-volatile memory.
Syntax
NET [ IP | GW | NM | PORT | DHCP | AD ] [ON | OFF | arg1 ]
command arg1 description
ip XXX.YYY.ZZZ.AAA set ip address
gw XXX.YYY.ZZZ.AAA set gateway address
nm XXX.YYY.ZZZ.AAA set network mask
port XXXX port number
dhcp ON | OFF DHCP
ad ON | OFF autodrop
Example
net ip 19216810010
net nm 25525500
net port 5678
net dhcp off
Returns None. Check error code.
NET ip arg1 Network ip address set (COMMAND)
Description
Sets the network ip address to arg1 (xxx.yyy.zzz.aaa)
Returns None. Check error code.
NET gw arg1 Network gateway address set (COMMAND)
Description
Sets the gateway ip address to arg1 (xxx.yyy.zzz.aaa)
Returns None. Check error code.
24
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL