Colby Instruments XT-100 - Page 31

NET nm arg1 Network socket port address set (COMMAND)
Description
Sets the network socket address to arg1
Returns None. Check error code.
NET port arg1 Network netmask set (COMMAND)
Description
Sets the network netmask to arg1 (xxx.yyy.zzz.aaa)
Returns None. Check error code.
NET ip arg1 Network ip address set (COMMAND)
Description
Sets the network ip address to arg1 (xxx.yyy.zzz.aaa)
Returns None. Check error code.
NET dhcp on | off Network dhcp enable set (COMMAND)
Description
Sets the DHCP enable for dynamic IP address (on) or static IP address (off).
Returns None. Check error code.
NET ad on | off Network autodrop socket connections (COMMAND)
Description
Sets the network autodrop old socket connections to (on) or (off).
Returns None. Check error code.
NET hostname arg1 Network set new hostname (COMMAND)
Description
Sets the network hostname to arg1.
Returns None. Check error code.
NET? Network (QUERY)
Description
The net? query retrieves the values for the currently set network addresses.
Note: if no network cable is connected, the IP address returned is invalid (e.g., 0.0.0.0).
Returns
IP=1921681008,NM=2552552550,GW=1921681001,
PORT=1234,DHCP=OFF,AD=ON
NET? hostname Network query hostname (QUERY)
Description
Returns the hostname network address.
Returns COLBY_YYMMNNNN
NETM? Network MAC-ID query (QUERY)
Description
The NETM? query returns the network MAC-ID address.
Returns MAC_ID=0000-0000-0000
25
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL