Colby Instruments XT-100 - Calibration Table Commands and Queries

63 Calibration Table Commands and Queries
CTSTORE arg1 arg2 Store one entry into calibration table
CTSTORE on | off Use calibration table command
CTSTORE save Save calibration table to NVRAM
CTSTORE load Load calibration table to memory
CTSTORE info Report calibration table information
CTSTORE reset Reset and clear calibration table
CTSTOREM Store multiple entries into calibration table
CTSTORE? Use calibration table query
CTSTORE? arg1 Query individual entries in calibration table
CTSTORE Calibration table parameter set (COMMAND)
Description
Operates on the in-memory calibration table. The in-memory calibration table (when enabled) will apply a
calibration position offset to ensure positional accuracy of the stepper motor.
Syntax
CTSTORE [ save | load | reset | on | off | info [arg1]]
save Stores in-memory calibration table into non-volatile random-access memory
(NVRAM).
load Load into memory the calibration table from NVRAM.
reset Clears all in-memory calibration table entries. Sets “no calibration” text entry into
the info setting.
on use Calibration table compensation (default)
off do not use Calibration table compensation when setting delay settings
info set the Calibration table text entry to [arg1]. 128x characters max.
Returns None
CTSTORE save Calibration table save (COMMAND)
Description Saves calibration table to non-volatile memory
Returns None
CTSTORE load Calibration table load (COMMAND)
Description Load calibration table from non-volatile memory
Returns None
22
COLBY INSTRUMENTS XT-100 VERSION 1.0 OPERATING AND PROGRAMMING MANUAL