- 21 -
4. DIRECTIONS FOR USE
4.1 MACHINE SAFETY WARNINGS
When using industrial equipment and plants, one must be aware of the fact that drive mechanisms
(rotary motion), high voltage components, as well as parts subject to high temperatures may cause
serious damages to persons and things.
Who is in charge of plant safety must be on the look-out that
l an uncorrect use or handling is avoided
l Safety devices must neither be removed nor tampered
l Only are original spare parts to be used especially as far as those components with safety
functions are concerned (ex.: protection microswitches, thermostat).
To achieve the above, the following is necessary:
l At working place an instruction manual relevant to the machine should be available.
l Such documentation must be carefully read and regulations must consequently be followed.
l Only must adequately skilled personnel be assigned to electrical equipment.
4.1.1 Machine configuration
The machine consists of two drive mechanisms for the running of the beater assemblies, of a
cooling unit with water condensation.
The product is prepared by filling the cooking cylinder or the freezing cylinder with the mix and
starting the automatic production cycle.
When the cycle ends, the product is ready to be dispensed by means the special levers.
Mix
End
product
To Next Page
Loading...
