Coldelite Compacta 3003 - MACHINE STARTING; DISPLAY AND CHANGE OF PROGRAMMABLE VALUES

COMPACTA
- 27 -
compacta_g - 02_05
CAUTION
Do not touch sanitized parts with hands, napkins or else, any longer.
4.3.3 Hygiene
Mildew and bacteria rapidly grow in mix fat contents.
To eliminate them, it is necessary to wash and clean all parts in contact with the product, as described above.
Stainless steel and plastic materials, as well as rubber used in the construction of the machines,
and also their particular shapes and designs make cleanout easy, but cannot prevent proliferation
of mildew and bacteria if not properly cleaned.
CAUTION
Before using the machine again, thoroughly rinse with just water, in order to eliminate any
residues of sanitizing solution.
4.4 MACHINE STARTING
When turning on the machine, the top display shows CMP and the lower one displays thee
version of installed programme.
Soon after the top display shows MOD, whilst the lower one displays a number corresponding
to the programming table of the machine.
NOTE:
Above codes are useful to inform technical service about the program type installed in the
machine.
4.4.1 Display and change of programable values
All operation parameters set by COLDELITE guarantee a profitable and first-quality production.
The operator can however change the cylinder heating temperature (heating/mixing side) as
well as the product consistency (production side) according to production needs.
The change of parameter value has to be carried out during the execution of the function involved:
l To have the access to the display of cylinder heating temperature, press the button
you find on the electronic control keyboard relevant to heating/mixing side.
On the display you will see the value blinking.
l To have the access to the display of the product consistency, press the button you
find on the electronic control keyboard relevant to production side.
On the display you will see the value blinking.
l To change the value, use keys INCREASE (for value increase) or DECREASE
(for value decrease).
l When you set the desired value, you can confirm it either by pressing again or
waiting for a few seconds.
5
502