- 23 -
4.2.2 Functions available to the operator
HEATING/MIXING SIDE
571.9 PROGRAMMING key
Ie enables the access to the display of the parameter relevant to the
CYLINDER HEATING TEMPERATURE. The parameter can be changed by
the operator by means of INCREASE and DECREASE keys.
571.4 SHOWER WATER INLET key
It activates water inlet for shower which stops when pressing again the
same key or by pressing STOP key. This function can always be activated.
CAUTION
Disable this key when you do not need it, so as to avoid possible damages to
the machine or to the operator.
571.2 BEATING key
It activates the beater running inside the heating cylinder.
The beater runs until you press STOP key.
NOTE:
After 3 minutes since beating activation, the machine automatically stops
in order to avoid a severe wear of beater and cylinder.
571.3 HEATING key
By this key you heat the product up to a temperature that can be set 50 °C
to 85°C, with beater on.
After selecting this function and pressing relevant key, the display will show
the heating temperature; pressing PROGRAMMING key you can vary the
temperature by means of INCREASE and DECREASE buttons. When the
temperature inside the cylinder has been reached, the heating cycle will
starts: time here, too, can be changed by pressing PROGRAMMING key and
following the same procedure as by the temperature change.
When heating is completed, the beater inside the cylinder will keep on
running unless you press STOP key; otherwise it will automatically stop 3
minutes later.
571.11 Increase key
By this button you can increase the programmable values on display.
571.1 Stop key
You can stop the function in progress and start another one.
To Next Page
Loading...
