- 43 -
7.2 WATERCOOLING
By machines with watercooled condenser, water must be drained from condenser on selling
season end, so as to avoid troubles in the event the machine is stored in rooms where
temperature may fall under 0°C.
- Withdraw water inlet and outlet pipes from their seat and let water flow out from circuit by
operating the machine a few seconds.
7.3 ORDERING SPARE PARTS
Should one or more parts wear out or break, place your order to a COLDELITE Technician and
always mention the machine type and its serial number stamped on data plate you find on the
machine rear.
7. MAINTENANCE
7.1 SERVICING TYPOLOGY
ATTENTION
Any servicing operation requiring the opening of machine panels must be carried out with
machine set at stop and disconnected from the main switch!
Cleaning and lubricating moving parts is forbidden!
Repairs of electrical and freezing plants must be carried out by skilled engineers!
Operations necessary to proper machine running are such that most of servicing is completed
during production cycle.
Servicing operations, such as cleaning of parts in contact with the product, replacing of
stuffing box, disassembling of beater assembly are to be carried out at the end of a working
day, so as to speed up serving operations required.
Herebelow you can find a list of routine servicing operations:
- Cleanout and replacement of stuffing box
Cleaning should be carried out at the end of a working day, whilst replacement only after
checking of stuffing box and in the event product drips inside drip drawer.
- Cleanout of beater assembly
At the end of a working day
- Cleanout of sliding shoes
At the end of a working day
- Cleanout of panels
To be carried out daily with neutral soap , seeing to it that cleansing solution never reaches
beater assembly in its inside.
- Cleanout and sanitization
At the end of every working day, according to procedures described in section 6.
CAUTION
Never use abrasive sponges to clean machine and its parts, as it might scratch their
surfaces.
To Next Page
Loading...
