compacta_g - 02_05
PRODUCTION SIDE
571.10 PROGRAMMING key
It enables the access to the display of the value relevant to the PRODUCT
CONSISTENCY. The parameter can be changed by the operator through
INCREASE and DECREASE keys.
571.7 START key
It allows to start the cycle or the function selected.
571.6 CLEANOUT key
It allows the beater of freezing cylinder to run, without connecting thecooling
unit. The beating time in cleanout mode can be programmed and it also applies
to distribution .
Beater speeds:
- in ice cream freezing side .............................................................Normal speed
571.8 DISTRIBUTION key
By this key ice cream dispense from freezing cylinder is allowed. Beating time
is programable and also applies to cleanout.
Distribution speeds:
- in ice cream freezing side .................................................................High speed
571.12 Decrease or program selection key
By this button you can decrese the modifiable value on display and select in
a sequence all production semi-automatic cycles programmed for this machine.
571.5 Stop key
The STOP button allows to stop the function in progress and to start a new
one.
To Next Page
Loading...