compacta_g - 02_05
WARNING
When installing the machine, insert a differential magnetothermal protection switch on all
poles of the line, adequately sized to the absorption power shown on machine data plate and
with contact opening of 3 mm at least.
- Never put your hand into the machine, alike during production and cleaning operations.
Before carrying out any maintenance operation, make sure that the machine is in “STOP/
RESET” position and main switch has been cut out.
- It is forbidden to wash the machine by means of a bolt of water under pressure.
- It is forbidden to remove panels in order to reach the machine inside before disconnecting
the machine.
- COLDELITE is not responsible for any accident that might happen during operation,
cleaning and/or servicing of its units, if this warning has not been fully complied with.
To Next Page
Loading...
