Colibri e-DaVinci - Positioning the Unit; Cycle Start Pedal Cable Connection

User Manual 7
2.3 Positioning the Unit
Once all the components have been removed from the package, prepare the unit (machine body),
operating as follows:
¾ With the unit in vertical position,
unfold the work surface, then place
the unit in a horizontal position on
a table or on a proper support
plane and set it in a way you can
reach comfortably.
As stated above on section 2.1
“Choosing the installation site”, the
table or surface where you place
the unit, must be perfectly level.
2.4 Cycle start pedal cable connection
1) Insert the connector (a) of the pedal
connection cable (b) into the socket
(c) on the backside of the unit.
c
a
b