14
User Manual
Check that the length of the
book does not exceed the
length of the CoLibrì cover
chosen. For correct trimming
and welding make sure that
the excess part of the cover
on the top to be trimmed is at
least 15 mm [5/8”].
CoLibrì transparent Document Pockets to Encapsulate/Wrap Documents, Drawings, Maps, Small
Objects, etc.
The section (d) of guide shows a summary of the CoLibrì transparent document pockets sizes
available (up to “A1”) including the dimensions of the documents/objects to be
wrapped/encapsulated (expressed in cm as well as in inches).
4.2 Covering/Wrapping Procedures
The following procedures explain how to correctly and safely apply covers/document pockets to
books, magazines, objects, etc. In particular instructions are provided for the following:
♦ How to Cover Softcover Books
♦ How to Cover Hardcover Books
♦ How to Encapsulate / Wrap Documents or Objects
4.2.1 Operating Precautions
¾ The CoLibrì
e-DaVinci book covering machine may only be used to cover/wrap books,
magazines, documents, projects, photos, objects, etc.
Only adults are permitted to use the book covering machine. Children or not properly trained
persons are not permitted to use the unit.
Moreover, the CoLibrì
e-DaVinci book covering machine may be used to trim and weld only
covers and document pockets bearing the original CoLibrì marking, or other material approved
by the manufacturer. The CoLibrì system’s covers/document pockets are the result of in-depth
research and development. In particular, they are made of a special highly transparent, non-
toxic, odourless, water resistant material, which is up to 60% air-permeable. The covers are
specially manufactured for softness. In addition, the covers/document pockets of the CoLibrì
system do not release fumes or harmful vapours during the welding process, thus avoiding the
need to install supplementary suction systems.
To Next Page
Loading...