20
User Manual
2. Insert the back cover of the book (c) into
the right pocket (d) of the cover, sliding it
down flush with the bottom edge of the
pocket.
3. Close the book and insert the part of cover
to be trimmed (min. 15 mm [5/8”]) on the
top side into the trimming/welding slot of
the unit. Before trimming, check that the
bottom edge of the CoLibrì cover is
parallel with the horizontal reference lines
on the work surface of the unit; if necessary
adjust the position of the pocket.
If the cover is not perfectly parallel, it could
be too narrow or too wide
c
d
NO!
OK!
To Next Page
Loading...