Collamat S Series - Technology; Software;Firmware

Collamat S Series
Technology
Release: V1.15/05/2013 7
2 Technology
2.1 Software/Firmware
The control program for the Collamat S has the following
features:
 dual processor hardware allows for rapid parallel
processing for communication and
 drive control
 modern user interface
 preset and print run counter
 impulse suppression for path-dependent suppression of the
label scanning for applications such as printed or
transparentlabels
 impulse suppression for path-dependent suppression of the
goods scanning after labeling process
 programmable settings for label position
 programmable settings for pre-dispensing
 multiple labeling with electronic adjustment of label offset
 automatic adjustment of dispensing speed with
measurement of goods speed using an incremental encoder
 storage of 99 labeling programs
 password protection with multiple access levels
 monitoring of almost empty label supply (LLO - optional) and
of out of label situation (OOL),
 open counter-pressure roller in traction unit (TUO), rewinder
full (RWF - optional),
 motordriver OK, ...
 non-stop operation with 2 Collamat S systems = interruption-
free labeling
 multilingual user interface
 automatic setup of optical label sensor
 all operational steps possible during labeling
 control of all peripheral devices from the program - without
potentiometers, switches, etc .....
 motorized (optional) rewinder unit for labeling
speeds > 40 - 50 m/min
 infinitely adjustable paper brake
 error / warning management - every exception status (input)
that could influence labeling can be configured
from the operator panel as an error, warning, or as a
situation to be ignored.