34
WORK
WORKWORK
WORK
WORK PREPARATION
WORK PREPARATIONWORK PREPARATION
WORK PREPARATION
1. Connect the connector (1) to the battery
1
2. Press the brush switch (2)
3. Press the suction switch (3)
3 2
4. Act on the cock lever (4) to adjust the detergent solution quantity: it should be
enough to regularly wet the floor but not as much as to flow out the splashguard.
Please not the right solution quantity depends on floor type, on dirt importance and
on speed.
5. Release the pedal and let the base lower.
6. Lower the squeegee acting on the lever (5).
5
4
7. Acting on the deadman lever (6) the brushes start turning and the squeegee starts
drawing in.
8. During the first few metres check that the amount of water is sufficient and that the
squeegee dries the floor perfectly.
6
To Next Page
Loading...
