36
UPON COMPLETION OF WORK
UPON COMPLETION OF WORKUPON COMPLETION OF WORK
UPON COMPLETION OF WORK
At the end of the work, and before performing any type of maintenance:
1. Close the cock by lever (1).
2. Raise base by pedal.
3. Raise squeegee by lever (2)
2
1
4. Turn off the brush switch (3).
5. Turn off suction motor switch (4).
ATTENTION!
ATTENTION! ATTENTION!
ATTENTION! If after having switched off the brush switch (3) the display
of the battery indicator remains on, this means that, the solution cock is
open. Close the water cock through the lever (1) in order to avoid leakage
of the detergent solution.
6. Move the machine to the water disposal point.
4
3
7. Hold the pipe placed on the back of the machine.
8. Remove the outlet cap and empty the tank.
ATTENTION!
ATTENTION!ATTENTION!
ATTENTION! Always wear gloves during this procedure to avoid any
contact with dangerous substances.
9. Disassembly the brush and clean it by a jet of water (for the disassembly of the
brush see the following “DISASSEMBLY OF THE BRUSH”)
To Next Page
Loading...
