COMAC ABILA 52 - Daily Maintenance; Recovery Tank Cleaning; Suction Filter Cleaning; Squeegee Cleaning

37
DAILY MAINTENANCE
DAILY MAINTENANCEDAILY MAINTENANCE
DAILY MAINTENANCE
RECOVERY TANK CLEANING
RECOVERY TANK CLEANINGRECOVERY TANK CLEANING
RECOVERY TANK CLEANING
1.
Hold the recovery tank outlet pipe.
2.
Remove the outlet cap and empty the tank.
ATTENTION!
ATTENTION!ATTENTION!
ATTENTION! Always wear gloves during this procedure, to avoid any
contact with dangerous substances.
3. Lift the recovery tank lid.
4.
Remove the suction cap (1) turning it anticlockwise.
5.
Remove the filter and its protection.
6.
Rinse the tank with a jet of water.
1
SUCTION FILTER CLEANING
SUCTION FILTER CLEANINGSUCTION FILTER CLEANING
SUCTION FILTER CLEANING
1.
Lift the lid.
2.
Remove the suction cap turning in anticlockwise.
3.
Remove the filter.
4.
Clean the filter walls and bottom by a jet of water.
5.
Carry out the cleaning procedures very carefully.
6.
Reassemble everything.
SQUEEGEE CLEANING
SQUEEGEE CLEANINGSQUEEGEE CLEANING
SQUEEGEE CLEANING
The squeegee must be in perfect working condition to achieve a good drying process.
Proceed as follows to clean it:
1.
Remove the pipe from the squeegee.
2.
Loose the knobs (1) shown in picture.
3.
Remove the mouth and clean it.
4.
Carefully clean the inside of the squeegee.
5.
Carefully clean the squeegee rubbers.
6.
Reassemble everything.
1