16
DAILY MAINTENANCE
CLEANING THE RECOVERY TANK
1. Grasp the recovery tank drainage tube.
2. Remove the drainage cap and empty the tank.
WARNING! This operation must be carried out wearing gloves to protect
against contact with dangerous solutions.
3. Raise the recovery tank cover.
4. Unthread the suction cap (1) by rotating it anticlockwise.
5. Remove the filter and relative protection.
6. Rinse the tank with a water jet.
1
CLEANING THE SUCTION FILTER
1. Raise the cover.
2. Unthread the suction cap by rotating it anticlockwise.
3. Unthread the filter.
4. Use a jet of water to clean the walls and base of the filter.
5. Carry out the cleaning operations carefully.
6. Reassemble all the elements.
CLEANING THE SQUEEGEE
Check the squeegee is always clean, for better drying results.
To clean it you must:
1. remove the tube from the squeegee
2. loosen the knobs (1) shown in the figure
3. remove and clean the nozzle
4. carefully clean inside the squeegee
5. carefully clean the squeegee rubbers
6. reassemble all the elements
1
To Next Page
Loading...
