6
GENERAL SAFETY REGULATIONS
The regulations below must be carefully followed in order to avoid harm to the operator and damage to the machine.
Read the labels on the machine carefully. Do not cover them for any reason and replace them immediately if they become
damaged
The machine must be used exclusively by authorised, trained personnel
During the working of the machine, pay attention to other people and especially to children
Do not mix different types of detergent as this may produce harmful gases
Do not place any liquid containers on the machine
The storage temperature must be between -25°C and +55°C
Conditions of use: room temperature between 0°C and +40°C with relative humidity between 30 and 95%
Do not use the machine in an explosive atmosphere
Do not use the machine as a means of transport
Do not use acid solutions that could damage the machine and/or harm people
Avoid working with the brushes when the machine is standing still, so as not to damage the floor
Do not vacuum inflammable liquids
Do not use the device to collect dangerous powders
In the event of a fire, use a powder extinguisher. Do not use water
Do not knock against shelving or scaffolding, where there is a danger of falling objects
Adapt the speed to the adhesion conditions
Do not use the machine on surfaces with an inclination greater than the one shown on the plate
The machine is designed to carry out the washing and drying operations simultaneously. Different operations should only be
carried out in areas where the passage of unauthorised persons is prohibited. Signal the presence of damp floors with
suitable signs
If the machine does not work properly, check this is not caused by failure to carry out routine maintenance. Otherwise,
request the intervention of the COMAC technical service
If you need to replace any components, request the ORIGINAL spare parts from a COMAC dealer and/or Authorised
Retailer
Use only original COMAC brushes indicated in the paragraph “CHOOSING AND USING THE BRUSHES"
For all cleaning and maintenance interventions, disconnect the machine from the power supply
Restore all electrical connections after any maintenance interventions
Do not remove any protection devices which require the use of tools in order to be removed
Do not wash the machine with direct water jets or with pressurised water, nor with corrosive substances
After every 200 hours of operation, have the machine checked by a COMAC assistance centre
To prevent the formation of scale in the solution tank filter, do not fill the tank with detergent solution many hours before
using the machine
Before using the machine, check that all the hatches and covers are positioned as shown in this Use and Maintenance
Manual
Before removing the recovery tank, check it is empty
When disposing of consumption materials, observe the laws and regulations in force
When your COMAC machine has reached the end of its long working life, dispose of the materials it contains (especially
oils, batteries and electronic components) in an appropriate manner, and bearing in mind that the machine itself was
constructed using 100% recyclable materials
To Next Page
Loading...
