40
PERFORMANCE
PERFORMANCEPERFORMANCE
PERFORMANCE
ATTENTION!
ATTENTION! ATTENTION!
ATTENTION! Whenever problems during operating occur, lower
promptly the lever of the emergency brake placed on the rear right
side of the machine. This command will block immediately the traction
of the machine.
To restart the machine again, press the releasing trigger and lift the
lever of the emergency brake; then push forward the lever on the
handle bar.
SQUEEGEE AUTOMATIC-MANUAL
SQUEEGEE AUTOMATIC-MANUALSQUEEGEE AUTOMATIC-MANUAL
SQUEEGEE AUTOMATIC-MANUAL
The machines with automatic version have the possibility to control electrically the
squeegee movement. Depending on the position of the switch (1) the following
functioning systems are activated.
Automatic
AutomaticAutomatic
Automatic If the switch is placed on automatic, lowering of the squeegee and starting
of the suction motor are obtained with the machine advancement. Also,
lifting of the squeegee and stopping of the suction motor are achieved with
the reverse motion of the machine.
Manual
ManualManual
Manual
If the switch is placed on manual, the squeegee lifts and lowers itself
manually through the commutator (2). The operation of the suction motor
is commanded anyhow through the squeegee.
1
2
AUTO
MAN
BRUSHES PRESSURE MANUAL
BRUSHES PRESSURE MANUALBRUSHES PRESSURE MANUAL
BRUSHES PRESSURE MANUAL
Brushes pressure can be adjusted through the lever shown in the figure. There are three
predetermined positions. Major is the pressure when the lever is in the highest position.
The pressure must be chosen based upon the type of floor and the type of dirt.
Excessive pressure causes higher brushes wear and major energy consumption.
BRUSHES PRESSURE WITH AUTOMATIC CONTROL
BRUSHES PRESSURE WITH AUTOMATIC CONTROLBRUSHES PRESSURE WITH AUTOMATIC CONTROL
BRUSHES PRESSURE WITH AUTOMATIC CONTROL
In case of machines equipped with automatic control (machines with actuator), the lever
for the adjustment of the brushes pressure allows four different levels. Also in this case,
major is the pressure onto the brushes when the lever is in its highest position.
To Next Page
Loading...
