COMAC OMNIA 32 - Excessive Foam Production; The Suction Motor Does Not Function

48
TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDETROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE
THE SUCTION MOTOR DOES NOT FUNCTION
THE SUCTION MOTOR DOES NOT FUNCTIONTHE SUCTION MOTOR DOES NOT FUNCTION
THE SUCTION MOTOR DOES NOT FUNCTION
1.
Check that the signal lamp of the suction motor switch is on
2.
Check whether the recovery tank is full; eventually empty it
3.
In the automatic versions, the suction motor works only when the squeegee is
lowered. Check that the selector is on the “AUTO” position and move forward of
some metres.
4. Check the perfect float condition of the recovery tank filter (see under “CLEANING OF
THE RECOVERY TANK FILTER”)
EXCESSIVE FOAM PRODUCTION
EXCESSIVE FOAM PRODUCTIONEXCESSIVE FOAM PRODUCTION
EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If required, add a small quantity of
antifoam liquid into the recovery tank.
Remember that, when the floor is not very dirty, more foam is generated. In this case
dilute more the detergent.