PROBLEM POSSIBLE CAUSE SOLUTION
THE SQUEEGEE
DOES NOT DRY
PERFECTLY
The vacuum unit is obstructed.
Make sure that the squeegee is free of obstructions
(read paragraph “CHECKING AND CLEANING THE
SQUEEGEE UNIT”).
Make sure that the vacuum hose is free of obstructions
(read paragraph “CHECKING AND CLEANING THE
VACUUM HOSE”).
Make sure the vacuum cap lter is free of obstructions
(read “CHECKING AND CLEANING THE RECOVERY
TANK FILTER-FLOAT”).
The cap on the recovery tank drainage hose is not
properly positioned.
Check that the cap on the recovery tank drainage hose
is positioned properly.
The recovery tank cover is not positioned correctly.
Check that the recovery tank cover is properly
positioned on the appliance.
EXCESSIVE FOAM
PRODUCTION
The detergent being used is not suitable.
Check that a low foam detergent has been used. If
necessary, add a small quantity of antifoam liquid to
the recovery tank.
The oor is not very dirty. Dilute the detergent more.
THE DEVICE DOES
NOT VACUUM
CORRECTLY
The recovery tank is full.
Empty the recovery tank (read the section “CHECKING
AND CLEANING THE RECOVERY TANK”).
The vacuum device is obstructed
Read the section "THE SQUEEGEE DOES NOT DRY
PERFECTLY".
To Next Page
Loading...
