COMAC VERSA 65BT - Disposal; Choosing and Using Brushes

59
DISPOSAL
To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
• Brushes
• Felt
• Electric and electronic parts*
• Batteries
• Plastic parts (tanks and handlebars)
• Metal parts (levers and frame)
(*) In particular, contact your distributor when scrapping electric and
electronic parts.
CHOOSING AND USING BRUSHES
POLYPROPYLENE BRUSH (PPL)
Used on all types of oors. Good resistance to wear and tear, and hot water (no greater than 50°C.). The polypropylene is non-hygroscopic
and therefore retains its characteristics even when working in wet conditions.
ABRASIVE BRUSH
The bristles of this type of brush are charged with highly aggressive abrasives. It is used to clean very dirty oors. To avoid oor damage, work
only with the pressure strictly necessary.
THICKNESS OF THE BRISTLES
Thicker bristles are more rigid and are therefore used on smooth oors or oors with small joints.
On uneven oors or those with deep joints, it is advisable to use softer bristles which can enter the gaps more easily.
Remember that when the bristles are worn and therefore too short, they will become rigid and are no longer able to penetrate and clean deep
down. In this case, like with over-large bristles, the brush tends to jump.
PAD HOLDER
The pad holder is recommended for cleaning shiny surfaces.
There are two types of pad holder:
1. The traditional pad holder is tted with a series of anchor points that allow the abrasive oor pad to be held and dragged while working.
2. the CENTRE LOCK type pad holder not only has anchor points, but also a snap-type central locking system in plastic that allows the
abrasive oor pad to be perfectly centred and held without any risk of it becoming detached. This type of pad holder is recommended above
all for machines with more than one brush, where the centring of the abrasive discs is difcult.
RED PAD
Suitable for frequent use on relatively clean oors. Even cleans without water, and polishes by removing marks.
GREEN PAD
Suitable for removing surface layers of wax and for preparing the ooring for subsequent treatments. For wet use.
BLACK PAD
Suitable for wet scraping heavy layers of wax. Removes the old nish, and eliminates burrs in concrete.
APPLIANCE
No. OF
BRUSHES
CODE
TYPE OF
BRISTLES
Ø BRISTLES Ø BRUSHES.
BRUSH
LENGTH
NOTES
ANTEA 50B
ANTEA 50BT
1 404653 PPL 0.9 508 - BLACK BRUSH
1 404654 PPL 0.3 508 - BLUE BRUSH
1 405631 PPL 0.6 508 - WHITE BRUSH
1 405632 ABRASIVE 508 - BRUSH
1 405527 497 - PAD HOLDER
ANTEA 50BTS
VERSA 50BTS
1 405639 PPL 0.5 110 500 FRONT BRUSH (WHITE)
1 405641 ABRASIVE 110 500 FRONT BRUSH
1 405640 PPL 0.3 110 500
REAR BRUSH (LIGHT
BLUE)