IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
This is a bit array containing status of logical binary outputs 128-143 of the
controller. Bit0 represents LBO128, bit1 represents LBO129 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
This is a bit array containing status of the binary outputs Remote control1 ...
Remote control8.
Group: Info
Value: Controller mode
This value contains actual controller mode. The controller mode is selected by the
setpoint Controller mode but the setpoint position can be overriden by binary
inputs Remote OFF, Remote MAN, Remote AUT or Remote TEST.
Major and minor firmware version number. E.g. value "2,4" means version 2.4.
Release version number is not included.
To Next Page
Loading...
Need help?
General
