IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
Code of the application type. E.g. 1 for SPtM, 2 for SPI, 3 for MINT etc. The value
is intended for diagnostic purposes.
Firmware branch code. Contains 1 in case of standard branches.
This value contains encrypted serial number of the controller and administrator
password and is intended for retrieving of the lost password. Send this number
together with controller serial number to your distributor if you need to retrieve
your password.
Bits of this value show "1" if the bank controller receives messages from the
another bank controller which has address corresponding with the bit position. Bit
0 represents address 1 etc. This value contains information about controllers with
addresses 1-16.
NOTE:
The bit which corresponds to the own controller is always set to "1".
Bits of this value show "1" if the bank controller receives messages from the
another bank controller which has address corresponding with the bit position. Bit
0 represents address 17 etc. This value contains information about controllers
with addresses 17-32.
NOTE:
The bit which corresponds to the own controller is always set to "1".
To Next Page
Loading...
Need help?
General
