ComAp IG-NTC GC - Page 257

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
257
Alarm output: PLC State 1
Related FW
3.0
Description
The output is closed while the alarm generated by the PLC block Force prot 1 is
present in the alarm list.
NOTE:
The actual text, which appears in the alarm list, can be changed in GenConfig.
Alarm output: PLC State 2
Related FW
3.0
Description
The output is closed while the alarm generated by the PLC block Force prot 2 is
present in the alarm list.
NOTE:
The actual text, which appears in the alarm list, can be changed in GenConfig.
Alarm output: PLC State 3
Related FW
3.0
Description
The output is closed while the alarm generated by the PLC block Force prot 3 is
present in the alarm list.
NOTE:
The actual text, which appears in the alarm list, can be changed in GenConfig.
Alarm output: PLC State 4
Related FW
3.0
Description
The output is closed while the alarm generated by the PLC block Force prot 4 is
present in the alarm list.
NOTE:
The actual text, which appears in the alarm list, can be changed in GenConfig.
Alarm output: UnivState 1
Related
FW
3.0
Description
The output is closed while the alarm generated by the Universal analog protection, where
the Message #1 is used, is present in the alarm list.
NOTE:
The actual text of the message depends on configuration.