ComAp IG-NTC GC User Manual

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
93
Related FW
3.0
Description
Use this setpoint to enter the user name for the SMTP server if SMTP
authentification is enabled.
Setpoint: SMTP password
Group
Comms settings
Range [units]
max. 32 characters [-]
Related FW
3.0
Description
Use this setpoint to enter the password for the SMTP server if SMTP
authentification is enabled.
Setpoint: SMTP address
Group
Comms settings
Range [units]
max. 32 characters
Related FW
3.0
Description
CAUTION!
Proper setting of SMTP-related setpoints as well as controller mailbox are
essential for sending alerts via e-mails.
This setpoint is used for entering the domain name (e.g. smtp.yourprovider.com)
or IP address (e.g. 74.125.39.109) of the SMTP server. Please ask your internet
provider or IT manager for this information.
NOTE:
You may also use one of free SMTP servers, e.g. smtp.gmail.com. However,
please note that some free SMTP servers may cause delays (in hours..) when
sending e-mails.
NOTE:
If you do not want to send active e-mails, you may leave this setpoint blank, as
well as other setpoints related to SMTP server and e-mail settings.
Setpoint: Contr mailbox
Group
Comms settings
Range [units]
max. 32 characters [-]
Related FW
3.0
Description
Enter an existing e-mail address into this setpoint. This address will be used as
sender address in active e-mails that will be sent from the controller. Do not
enter your or other recipient's e-mail address. Recipient's addresses are to be
entered into the setpoints AcallCH1-Addr, AcallCH2-Addr and AcallCH3-Addr.
NOTE:
Most of SMTP server will reject sending e-mails that contain nonexisting address
in the sender address field.

ComAp IG-NTC GC Specifications

General

Brand	ComAp
Model	IG-NTC GC
Category	Controller
Language	English