InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
This data object is intended for remote control of the IntelliMains via the
communication if some kind of data is to be passed into the controller.
This object can be written via the communication (e.g. Modbus) without any
limitation. Use GenConfig function Generate Cfg Image to get the
communication object number or register number of this particular value
object. See an example at the object ExtValue1.
13.1.7 Group: Load shedding
13.1.7.1 Value: StatLdShed
The value indicates the current load shedding stage. 0 indicates that the load
shedding is not active. See the chapter Load shedding for more details.
13.1.8 Group: Analog CU
13.1.8.1 Value: UBat
Voltage at the controller power supply terminals.
13.1.8.2 Value: CPU Temp
Temperature inside the controller (on the CPU).
To Next Page
Loading...
