Name: ComAp InteliVision 5
Brand: ComAp
Rating: 4 (1 reviews)

To Next Page

To Previous Page

InteliVision 5 - New Features List

14.2 How to program InteliVision 5

For programming of new firmware, upgrade of fonts and logo download the InteliVision 5 has to be

connected to any IG/IS-NT-(BB) controller to it’s NT-terminal interface, i.e. RS485(1)/display port.

Then the programming is done from GenConfig tool:

1. Go to File → Firmware upgrade and Cloning → Display GC font change / FW upgrade

2. Select tab according to desired operation, e.g. Display firmware upgrade

3. Select firmware to be programmed (in this case InteliVision5-1.1.1)

4. Press Write to display button and wait until programming is complete

5. Disconnect InteliVision 5 from the controller NT-terminal interface.

Other manuals for ComAp InteliVision 5

Questions and Answers:

Need help?

Do you have a question about the ComAp InteliVision 5 and is the answer not in the manual?

General