ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
129
Related FW
3.0
Description
The setpoint adjusts the communication speed on the COM1 connector when it is
switched to MODBUS or MODBUS-MDM(HW) mode. See also the setpoint
RS232(1) mode.
Setpoint: RS232(2)MBCSpd
Group
Comms settings
Range [units]
9600, 19200, 38400, 57600 [bps]
Related FW
3.0
Description
The setpoint adjusts the communication speed on the COM2 connector when it is
switched to MODBUS or MODBUS-MDM(HW) mode. See also the setpoint
RS232(2) mode.
Setpoint: RS232(1)MdmIni
Group
Comms settings
Range [units]
[-]
Related FW
3.0
Description
This setpoint can be used to add extra AT commands at the end of the
initialization sequence of the modem connected to the COM1 port. The command
can be entered with as well as without the "AT" prefix, are separated with
semicolon and maximal length is 31 characters.
The setpoint can't be modified via the IG-NT built-in terminal.
Setpoint: RS485(1) conv.
Group
Comms settings
Range [units]
DISABLED, ENABLED [-]
Related FW
3.0
Description
This setpoint selects function of the built-in RS485(1) converter.
ENABLED
The communication port COM1 is redirected to the integrated
RS485(1) converter. The RS232(1) connector has no function
and the external display interface is not available.
DISABLED
The communication port COM1 is present at the RS232(1)
connector and the RS485(1) connector is used for the external
display interface.
NOTE:
The redirection is applied only for DIRECT, MODBUS and ECU-LINK modes. See
the setpoint RS232(1) mode.
NOTE:
This setpoint must be set to DISABLED at controllers that do not have internal
display. i.e. InteliVision-5 or InteliVision-8 is connected to the RS485(1) terminals.

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English