ComAp IS-NTC-BB

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
228
Units
V
Related FW
3.0
Description
Generator voltage in phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V
Group
Gener values
Units
V
Related FW
3.0
Description
Generator voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V L1-L2
Group
Gener values
Units
V
Related FW
3.0
Description
Generator voltage between phases L1 and L2.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V L2-L3
Group
Gener values
Units
V
Related FW
3.0
Description
Generator voltage between phases L2 and L3.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.
Value: Gen V L3-L1
Group
Gener values
Units
V
Related FW
3.0
Description
Generator voltage between phases L3 and L1.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint VT ratio.