ComAp IS-NTC-BB

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
231
Value: Bus V L1-N
Group
Bus values
Units
V
Related FW
3.0
Description
Bus voltage in phase L1.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vb VT ratio.
Value: Mains V L2-N
Group
Mains values
Units
V
Related FW
3.0
Description
Mains voltage in phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vm VT ratio.
Value: Bus V L2-N
Group
Bus values
Units
V
Related FW
3.0
Description
Bus voltage in phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vb VT ratio.
Value: Mains V L3-N
Group
Mains values
Units
V
Related FW
3.0
Description
Mains voltage in phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vm VT ratio.
Value: Bus V L3-N
Group
Bus values
Units
V
Related FW
3.0
Description
Bus voltage in phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vb VT ratio.