IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Code of the application type. E.g. 1 for SPtM, 2 for SPI, 3 for MINT etc. The value
is intended for diagnostic purposes.
Value: SW Branch
Firmware branch code. Contains 1 in case of standard branches.
Value: PasswordDecode
This value contains encrypted serial number of the controller and administrator
password and is intended for retrieving of the lost password. Send this number
together with controller serial number to your distributor if you need to retrieve
your password.
Value: CAN16
Bits of this value show "1" if the controller receives messages from the controller
which has address corresponding with the bit position. Bit 0 represents address 1
etc. This value contains information about controllers with addresses 1-16.
NOTE:
The bit which corresponds to the own controller is always set to "1".
Value: CAN32
Bits of this value show "1" if the controller receives messages from the controller
which has address corresponding with the bit position. Bit 0 represents address
17 etc. This value contains information about controllers with addresses 17-32.
NOTE:
The bit which corresponds to the own controller is always set to "1".
Value: Reg16
To Next Page
Loading...
