IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Binary output: LdShed stage 3
This output is used for control of third load group. This group is disconnected as
last one when the first two groups are already disconnected and the condition for
disconnecting of next group is still fulfiled.
NOTE:
Learn more about load shedding in the separate chapter Load shedding.
Binary output: TimerAct 1-4
This is combined output from timer channels 1-4. The output is closed if at least
one of the channels is active.
NOTE:
See the chapter Timers for more details about timers.
Binary output: TimerAct 5-8
This is combined output from timer channels 5-8. The output is closed if at least
one of the channels is active.
NOTE:
See the chapter Timers for more details about timers.
Binary output: TimerAct 9-12
This is combined output from timer channels 9-12. The output is closed if at least
one of the channels is active.
NOTE:
See the chapter Timers for more details about timers.
Binary output: TimerAct 13-16
This is combined output from timer channels 13-16. The output is closed if at least
one of the channels is active.
NOTE:
See the chapter Timers for more details about timers.
Binary output: TimerActiveCom
This is combined output from all timer channels. The output is active if at least one
timer channel is active.
To Next Page
Loading...
Need help?
General
