Serial Number Enter the serial numbers of the transmitters provided for your
installation. Note that the serial numbers are case sensitive, i.e.
BA03060001 is correct, ‘Ba’, ‘bA’ or ‘ba’ is incorrect and will not be
recognised.
Make this a Backbone unit (RF512 and RF513 only)
Those transmitters which have been identified as Backbone units
during the site survey must have this box ticked. Do not tick this
box for transmitters which have no mains adaptor connected.
Disable Display Tick this option to disable the LCD for those transmitters where the
local display is not required.
Radio Tx rate This setting controls the rate at which batches of readings are
transmitted to the Gateway. A drop-down-list of minute intervals is
presented, choose a default of 15 minutes unless a faster update
rate is necessary. Updating faster than 15 minutes has a
detrimental effect on battery life.
Add to Location Choose an administrative Location for this transmitter. Locations
are described fully in the Gateway User Manual
Enter your password and click the Save button. The newly added transmitter will be added to
the categorised list.
Gateway Programming and Use
This, the RF500 System Manual covers installation and commissioning of the RF500 Wireless
Monitoring system from a hardware point of view.
A Web-View Help manual for the RF500 Wireless Monitoring System is available online via
the Gateway itself. This is a detailed manual incorporating help and detailed information on
use of the Gateway and transmitters, including all the available screens.
To Next Page
Loading...
