DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-50
• Enter 02-ccc-13- 03 to program the Predefined No Answer destination for each CO Line to be forwarded
(where “ccc” = the CO Line directory number).
CO Line 1 = 740
CO Line 2 = 741
CO Line 3 = 742
CO Line 4 = 743
CO Line 5 = 744
CO Line 6 = 745
CO Line 7 = 746
CO Line 8 = 747
CO Line 9 = 748
CO Line 10 = 749
CO Line 11 = 750
CO Line 12 = 751
CO Line 13 = 752
CO Line 14 = 753
CO Line 15 = 754
CO Line 16 = 755
• Press [save ]. This advances to the selected CO Line Predefined Call Forward No Answer database item.
• Press [chg] to change the value of this data item.
• Input the appropriate destination. Valid entries are extension directory number (101-156), UCD/Hunt Group
Directory Numbers (410-433), or Virtual Directory Numbers (700-729)
• Press [save ] to store this new data.
• Continue making other changes as required.
• Exit programming mode when changes are complete.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu.
• Use ¢£¤¥ to highlight “CO Line.” Then press «.
• Use ¢£¤¥ to highlight “Answering Position.” Then press «.
• Use ¢£¤¥ to highlight “Pre-CFW NoAns.” Then press «.
• Press Enter to change the data item value.
• Input the appropriate No Answer destination for this CO Line. Then press «.
• Continue making other programming changes as required.
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
To Next Page
Loading...
