DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-66
Program extensions for CO Line Access. (01-101~156-23-01~16):
• Enter 01-xxx-23-yy to program “xxx” Extension for “yy” CO Line access.
• Press [save ]. This advances to CO Line Access for extension “xxx” and CO “yy.”
• Press [chg] until the appropriate value for this database item displays (Y/N).
• Press the Volume button (up or down) to return to the DB Item Select screen and input another
extension and CO Line
Or…
• Press [back ] or [next ] to select the previous or next sequential CO Line for the selected extension.
• Press [chg] until the appropriate value for this database item displays.
• When finished programming CO Line Access, press the Volume button (up or down) to return to the DB
Item Select screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
Program CO Line Access:
• Use ¢£¤¥ to highlight “Extension.” Then press «.
• Use ¢£¤¥ to highlight “Line Assignment.” Then press «. (Notice the display header “Extension –
[1/05].” The “[1/05],” indicates that this is the first of five pages for this database screen. Page 1 is extension
ports 1-14 (Extensions 101-114).)
• Use the ³ and ´ buttons on the PC keyboard to select the page for the extension(s) to be programmed.
• Use ¢£¤¥ to highlight the Line Assignment for the Extension. (CO Lines are listed along the top of
the display. Extensions are listed along the left side of the display.)
• Press « until the appropriate value displays.
• Continue making other programming changes as required.
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.
To Next Page
Loading...
