DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-70
Enter into CO Line Group Directory Swapping (07-01-01~08-04):
• Input 07-01-0g-04 (where “g” = the CO Line Group number, 1-8).
• Press [show ]. The current directory number assigned to this CO Line Group displays.
• Press [show ] to swap this directory number with another CO Line group directory number. (9, 800-809).
• Input the directory number that is to be used to access this CO Line Group. (Note: The selected number
must be assigned to this system resource in Flexible Numbering Plan.)
• Press [save ]. The data is stored.
• Press the Volume button (up or down) to return to the Database Item Select screen or press [next] to
enter another CO Line Group number for which the directory number is to be swapped.
• Continue making other programming changes or exit the programming mode.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
• Use ¢£¤¥ to highlight “CO Line Application.” Then press «.
• Use ¢£¤¥ to highlight “CO Line Group Directory Number Swapping.” Then press «. The current
CO Line Group numbers and the assigned directory number are displayed.
• Use ¢£¤¥ to highlight the appropriate CO Line Group under the column “DIR # Swapping.” Then
press «.
• Input the CO Line Group Directory Number for this CO Line Group.
• Press «. The database item is temporarily stored.
• Use ¢£¤¥ to highlight the next CO Line Group Directory Number to be changed.
• Repeat the programming process for all CO Line Groups necessary.
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.
To Next Page