Comdial DX-80 - Page 131

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-81
• Press [save ]. The data is stored.
• To program other Members press [next] or [back] to select the Member to change and repeat the process.
• Continue making other programming changes or exit the programming mode.
Program CO Lines for the Evening Ring Assignment (02-ccc-13-02):
• Input 02-ccc-13-02 (where “ccc” = the CO Line directory number 740-755 to be programmed). The first of
six possible Members (destinations) displays.
• Press [chg] to change the Evening assignment.
• Input the directory number where Evening mode ringing for this CO line is necessary. (Extensions: 101-156;
Hunt Groups: 410-433; Virtual Numbers 700-729.)
• Press [save ]. The data is stored.
• Continue making other programming changes or exit the programming mode.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
• Use ¢£¤¥ to highlight “CO Line.” Then press «.
• Use ¢£¤¥ to highlight “Answering Position.” Then press «.
• Use ¢£¤¥ to highlight the Day Member or Evening ringing destination for the CO Line (CO Line
numbers are listed vertically along the left side of the screen). Then press «.
• Input the CO Line, Hunt Group or Virtual Number directory number where ringing for this CO Line is to be
assigned.
• Press «. The database item is temporarily stored.
• Use ¢£¤¥ to highlight the next ringing destination to be programmed.
• Repeat the programming process for all CO Lines and destinations for the mode (Day/Evening).
• When you have completed all changes, press the ° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a “SEND” function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.