Comdial DX-80 - Page 143

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-93
Operation – Private Connection with a Conference Member (“Private Talk” – Conference
Controller Only)
1. While engaged in a conference the display shows:
XXX XXX XXX
private forced
2. Press [private]
PRESS DIR#
exit
3. Press [exit ] to abort the operation and return to the conference.
Or…
Dial the directory number (CO Line number or Extension number) to connect. (You may also simply press
the CO Line button or DSS button of the CO Line/extension to be connected.)
That conference party is removed from the conference and connected to you.
4. You may re-establish the conference with all members by pressing the Conference button.
Or…
Hang up on the current connection and rejoin the remaining member(s) by pressing the Hold button.
Hang up to end the conference/connection.
Conditions
a) The extension that establishes a conference is called the controlling party.
b) Only the conference controller can add a new conference connection (party).
c) Only the controlling party is allowed to invite or forcibly release any attending internal or external party, or to
setup a “private talk” with any one attending party.
d) When adding new parties to a conference and while speaking privately to a particular conference member
other members of the conference will be connected to Music On Hold.
e) Each of the calls involved in a holding conference will be placed on Exclusive Hold.
f) When the controlling party exits a conference, the most recently invited internal party will be designated as
the new controlling party.
g) When a conference is established, each party will hear a burst of conference tone when the Conference
Tone is enabled.
h) The Unsupervised Conference feature code !77 may be programmed on any available
programmable feature button.
i) Only the Controller of an Unsupervised Conference may rejoin an Unsupervised Conference.
j) Conference can only be established at a Digital Speakerphone.
Default Settings
Call Handling – CO Line Conference = 3 CO Lines. (Range is None/2/3.)
Call Handling – Unsupervised Talk Time = 0 (unlimited). (Range is 0-120 in 10-minute increments.)
Call Handling – Conference Tone = Y. (Range is Y/N.)
CO Line – Call Abandon = Y. (Range is Y/N.)
Programming Abstract
• Program the maximum CO Lines that may be in a conference (none, 2 or 3).
• Program the time allowed for Unsupervised Conferences (CO Line-to-CO Line).
• Program the Conference Tone for Yes or No operation.